Nissan Juke Service and Repair Manual : Engine Mechanical K9K

Other materials:

PTC branch line circuit
Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the PTC heater control unit for damage, bend and loose connection (unit side and connector side). Is the inspection re ...

System
4WD system : System Diagram INPUT/OUTPUT SIGNAL It transmits/receives each signal from the following 4WD control module via CAN communication line. 4WD system : System Description Х 4WD mode is selectable among 2WD, 4WD-V, and 4WD by operating the 4WD mode switch. Х When judging drivi ...

P1643 thermoplunger control unit
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect thermoplunger control unit harness connector. 3. Check the voltage between thermoplunger control unit harness connector and ground. Is the ...