Unit removal and installation

Engine assembly Exploded View 1. Engine torque rod 2. Engine mounting insulator 3. Engine mounting stay 4. Transaxle mounting stay 5. Engine mounting rear bracket 6. Transaxle torque rod ...

Engine stand setting

Preparing the engine to be on the stand Before the engine is mounted on the engine sub-attachment, the engine's electrical harness must be removed and the engine oil drained. 1. Remove the mult ...

Other materials:

B26F9 cranking request circuit
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26F9 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26F9 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, &qu ...

Li-ion battery temperature gauge
This gauge provides a real-time monitor for the operating temperature of the high-voltage Li-ion battery pack. The battery temperature is considered to be within the optimal operating range when the indicator is located within the designated zone 1 as depicted in the illus ...

EPS branch line circuit
Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the EPS control unit for damage, bend and loose connection (unit side and connector side). Is the inspection result no ...