Removal and Installation

REMOVAL 1. Remove rear propeller shaft assembly. Refer to DLN-121, "Removal and Installation". 2. Remove rear drive shaft. Refer to RAX-17, "Removal and Installation". 3. Disc ...

Electric controlled coupling

Exploded View 1. Filler plug 2. Gasket 3. Drain plug 4. Breather tube 5. Clip 6. Breather hose 7. Breather 8. sub-harness clip 9. sub-harness 10. Rear cover 11. Center stem 12. S ...

Other materials:

Additional service when removing battery negative terminal
Description • The NAVI control unit is equipped with the anti-theft system. • The NAVI control unit operates after authenticating a fixed four-digit anti-theft code. • After removing the battery of the NAVI control unit, the authentication of the anti-theft code is required. Work Procedure ...

P0131 A/F sensor 1
DTC Logic DTC DETECTION LOGIC To judge the malfunction, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal is not inordinately low. DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform ...

P range interlock door lock/unlock function does not operate
Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode. 3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”. Refer to DLK-217, "DOOR LOCK ...