Preparation

Special Service Tools Commercial Service Tools ...

Component parts

Engine control system : Component Parts Location 1. IPDM E/R Refer to PCS-5, "Component Parts Location". 2. Battery current sensor (with battery temperature sensor) 3. Mass air flow ...

Other materials:

P0643 sensor power supply
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Air cleaner and air duct
Exploded View 1. Hose clamp 2. PCV hose 3. Hose clamp 4. Air cleaner filter 5. Air cleaner filter case 6. Grommet 7. Inlet air duct (lower) 8. Grommet 9. Inlet air duct (upper) 10. Bracket 11. Air cleaner case 12. O-ring 13. Mass air flow sensor 14. Air duct A. To electric ...

Precaution Necessary for Steering Wheel Rotation after Battery Discon
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...