General Precautions

• Always use a 12 volt battery as power source. • Do not attempt to disconnect battery cables while engine is running. • Before connecting or disconnecting the ECM harness connector, turn ig ...

System description

...

Other materials:

P2119 electric throttle control actuator
DTC Logic DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. Turn ignitio ...

Additional service when replacing transaxle assembly
Description Perform the following work after the transaxle assembly is replaced. Erasing the calibration data • The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the ROM assembly (in the control valve). This enables the TCM to perform ac ...

System initialization
Description If any of the following operations are performed, the initialization is necessary for normal operation of power window system. • Disconnection and connection of battery cable from negative terminal. • When power window main switch replaced. • Electric power supply to power ...