Preparation

Special Service Tool ...

Cooling system

Cooling Circuit 1. Radiator 2. Reservoir tank 3. Heating elements (Thermo plungers) 4. Heater core 5. Exhaust gas cooler 6. Thermostat 7. Water pump 8. Water-oil heat exchanger 9. Ble ...

Other materials:

Refilling
1. Remove filler plug (1) and gasket from transaxle case. 2. Fill with new gear oil until oil level reaches the specified limit at filler plug mounting hole as shown in the figure. Oil grade and viscosity : Refer to MA-13, "Fluids and Lubricants". Oil capacity : Refer to TM-63, " ...

LAN System can system (type 9)
DTC/CIRCUIT DIAGNOSIS Main line between IPDM-E and DLC circuit Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector s ...

Brake pedal
Inspection and Adjustment INSPECTION Brake Pedal Height Check the height (H1) between the dash lower panel (1) and the brake pedal upper surface. H1 : Refer to BR-136, "Brake Pedal". CAUTION: Remove the floor trim. Stop Lamp Switch Check the clearance (C) among the brake pedal l ...