Precaution for Liquid Gasket

REMOVAL OF LIQUID GASKET • After removing the mounting bolts and nuts, separate the mating surface using a seal cutter and remove the liquid gasket. CAUTION: Be careful not to damage the mating ...

System description

...

Other materials:

Front wheel hub and knuckle
Exploded View 1. Steering knuckle 2. Splash guard 3. Hub bolt 4. Wheel hub assembly (Bearing-integrated type) 5. Disc rotor 6. Wheel hub lock nut 7. Adjusting cap 8. Cotter pin A. Tightening must be done following the installation procedure. Refer to FAX-11, "Removal and Insta ...

Security indicator lamp does not turn on or blink
Description Security indicator lamp does not blink when ignition switch is in a position other than ON. NOTE: • Before performing the diagnosis, check “Work Flow”. Refer to SEC-187, "Work Flow". • Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE (OPERAT ...

Power supply and ground circuit
Combination meter COMBINATION METER : Diagnosis Procedure 1.CHECK FUSE Check for blown fuses. Is the inspection result normal? YES >> GO TO 2. NO >> Be sure to eliminate cause of malfunction before installing new fuse. 2.CHECK POWER SUPPLY CIRCUIT Check voltage between comb ...