Nissan Juke Service and Repair Manual : SRS air bag warning lamp does not turn on

Diagnosis Procedure

1.CHECK COMBINATION METER POWER SUPPLY AND GROUND CIRCUIT

Check conbination meter unit power supply and ground circuit. Refer to MWI-51, "COMBINATION METER : Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK HARNESS CONNECTOR

Check the harness connector.

Is the inspection result normal? YES >> GO TO 3.

NO >> Replace harness connectors.

3.CHECK WIRING HARNESS

Check the wiring harness externals.

Is the inspection result normal? YES >> GO TO 4.

NO >> Replace wiring harness.

4.CHECK AIR BAG DIAGNOSIS SENSOR UNIT

Disconnect air bag diagnosis sensor unit connector and turn ignition switch ON.

Does air bag warning lamp turn ON? YES >> Replace air bag diagnosis sensor unit. Refer to SR-30, "Removal and Installation".

NO >> Replace combination meter. Refer to MWI-69, "Removal and Installation".

    SRS air bag warning lamp does not turn off
    Diagnosis Procedure 1.CHECK AIR BAG MODULE AND SEAT BELT PRE-TENSIONER Check the deployment of air bag module. Is air bag module deployed? YES >> Replace the malfunctioning parts. NO &g ...

    Other materials:

    When traveling or registering your vehicle in another country
    When planning to travel in another country, you should first find out if the fuel available is suitable for your vehicle’s engine. Using fuel with an octane rating that is too low may cause engine damage. All gasoline vehicles must be operated with unleaded gasoline. Therefore, avoid taking ...

    Keyfob battery
    Exploded View 1. Upper case 2. Key 3. Switch cover 4. Switch rubber 5. Board surface 6. Battery 7. plate 8. Lower case 9. Screw Removal and Installation REMOVAL 1. Remove screw (9) on the rear of keyfob. 2. Place the key with the lower case (8) facing up. Set a screw-driver wrap ...

    Air breather hose
    Removal and Installation REMOVAL 1. Remove air cleaner case. Refer to EM-26, "Removal and Installation". 2. Remove clip from bracket. 3. Remove air breather hose from transaxle assembly. INSTALLATION Note the following, and install in the reverse order of removal. CAUTION: Chec ...