Nissan Juke Service and Repair Manual : Removal and installation

OIL COOLER

Oil filter
Removal and Installation REMOVAL 1. Remove engine under cover. 2. Using oil filter wrench [SST: KV10115801 (J-38956)] (A), remove oil filter. : Vehicle front CAUTION: • Oil filter is provided ...

Exploded View
M/T models 1. Clamp 2. Water hose 3. Oil cooler 4. Water hose N·m (kg-m, in-lb) CVT models 1. Clamp 2. Water hose 3. Oil cooler 4. Water hose 5. Water hose 6. Heater thermostat ...

Other materials:

Precaution Necessary for Steering Wheel Rotation after Battery Discon
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

Brake pad wear warning
The disc brake pads have audible wear warnings. When a brake pad requires replacement, it will make a high pitched scraping sound when the vehicle is in motion. This scraping sound will first occur only when the brake pedal is depressed. After more wear of the brake pad, the sound will always ...

P0335 CKP sensor (POS)
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following proced ...