Nissan Juke Service and Repair Manual : Inspection

INSPECTION AFTER REMOVAL

Oil Cooler
Check oil cooler for cracks. Check oil cooler for clogging by blowing through engine coolant inlet. If necessary, replace oil cooler assembly.

INSPECTION AFTER INSTALLATION

1. Check the engine oil level and the engine coolant level and add engine oil and engine coolant. Refer to LU-8, "Inspection" and CO-11, "Inspection".

2. Start the engine, and check that there is no leakage of engine oil or engine coolant.

3. Stop the engine and wait for 10 minutes.

4. Check the engine oil level and the engine coolant level again. Refer to LU-8, "Inspection" and CO-11, "Inspection".

    Removal and Installation
    REMOVAL 1. Drain engine coolant. Refer to CO-11, "Draining". CAUTION: Perform when engine is cold. 2. Remove front bumper facia. Refer to EXT-12, "Exploded View". 3. Remove ...

    Other materials:

    Combination meter
    Reference Value VALUES ON THE DIAGNOSIS TOOL NOTE: Some items are not available according to vehicle specification. TERMINAL LAYOU PHYSICAL VALUES Fail-Safe FAIL-SAFE The combination meter activates the fail-safe control if CAN communication with each unit is malfunctio ...

    Diagnosis system (BCM)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the ...

    Basic inspection
    DIAGNOSIS AND REPAIR WORKFLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2.CHECK SYMPTOM • ...