Exploded View

M/T models 1. Clamp 2. Water hose 3. Oil cooler 4. Water hose N·m (kg-m, in-lb) CVT models 1. Clamp 2. Water hose 3. Oil cooler 4. Water hose 5. Water hose 6. Heater thermostat ...

Inspection

INSPECTION AFTER REMOVAL Oil Cooler Check oil cooler for cracks. Check oil cooler for clogging by blowing through engine coolant inlet. If necessary, replace oil cooler assembly. INSPECTION AFTE ...

Other materials:

C1604 torque sensor
DTC Logic DTC DETECTION LOGI DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE Wi ...

Rear-facing child restraint installation using LATCH
Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Follow these steps to install a rear-facing child restraint using the LATCH system: 1. Position the child restraint on the seat. Always follow the child restrain ...

L terminal circuit (open)
Description The “L” terminal circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the alternator is providing sufficient voltage with the engine running, the charge warning lamp will go off. If the charge warnin ...