Wheel alignment

Inspection DESCRIPTION CAUTION: • The adjustment mechanisms of camber, caster, and kingpin inclination angles are not included. • If camber, caster, or kingpin inclination angle is outside the s ...

Front coil spring and strut

Exploded View 2WD 1. Piston rod lock nut 2. Mounting insulator 3. Mounting bearing 4. Bound bumper 5. Coil spring 6. Lower rubber seat 7. Strut 8. Steering knuckle : N·m (kg-m, ft-lb) ...

Other materials:

P0340 CMP sensor (PHASE)
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Multi display unit
Reference Value VALUES ON THE DIAGNOSIS TOOL • *1:MR16DDT • *2: This is not used to determine ON/OFF of the indicator lamp. TERMINAL LAYOUT PHYSICAL VALUES DTC Inspection Priority Chart When multiple DTCs are displayed simultaneously, check one by one according to the following prio ...

Spark plug
Exploded View 1. Rocker cover protector 2. O-ring 3. PCV valve 4. PCV hose 5. Clamp 6. Rocker cover gasket 7. Rocker cover 8. Clamp 9. PCV hose 10. Oil filler cap 11. Spark plug 12. Ignition coil A. To air duct assembly B. Tightening must be done following the installation ...