Nissan Leaf 2018-2025 (ZE1) Owner's Manual : Rear window and outside mirror defroster switch

Type A rear window and side mirror defroster button on Nissan Leaf dashboard
Type A (if so equipped)

To effectively clear frost, fog, or condensation from the rear window glass and the outside rearview mirrors of your Nissan Leaf, ensure the power switch is in the ON position and press the defroster switch (1) to activate the system.

Once the system is active, the corresponding indicator light will illuminate on the console. To manually deactivate the heating elements at any time, simply push the switch again.

For your convenience, the system is designed to turn off automatically after approximately 15 minutes of operation to prevent unnecessary power consumption.

Type B rear window and side mirror defroster button on Nissan Leaf dashboard
Type B (if so equipped)

CAUTION

When performing interior maintenance or cleaning the inner side of the rear window, exercise great care to avoid scratching, scraping, or otherwise damaging the delicate electrical filaments of the rear window defroster grid, as this can compromise the system's performance.

    Wiper and washer switch
    WARNING When driving your Nissan Leaf in freezing conditions, please be aware that washer solution can freeze rapidly upon contact with a cold windshield, severely obscuring your view and creatin ...

    Other materials:

    P1225 TP sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

    System
    WITH AUTO A/C WITH AUTO A/C : System Diagram WITH AUTO A/C : System Description OPERATION DESCRIPTION • BCM detects that the rear window defogger switch turns ON when the ignition switch is ON, and then transmits the rear window defogger switch signal to IPDM E/R via CAN communication for ...

    Push-button ignition switch
    Removal and Installation REMOVAL 1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and Installation". 2. Remove the push-button ignition switch. 1. Disengage the push-button ignition switch fixing pawls using minus driver etc. 2. Press the push-button ignition switch to ...