Precautions for Drive Shaft

• Observe the following precautions when disassembling and assembling drive shaft. - Never disassemble joint sub-assembly because it is non-overhaul parts. - Perform work in a location which i ...

Special Service Tool

...

Other materials:

P1574 ASCD vehicle speed sensor
Description The ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to EC-477, "AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Sy ...

Parking lamp circuit
Without daytime running light system WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Component Function Check 1.CHECK PARKING LAMP OPERATION CONSULT-III ACTIVE TEST 1. Select “EXTERNAL LAMPS” of IPDM E/R active test item. 2. With operating the test items, check that the parking lamp is turned ON. T ...

ECU diagnosis information
ECM Reference Value TERMINAL LAYOUT PHYSICAL VALUES NOTE: • ECM is located in the engine room left side near battery. • When disconnecting ECM harness connector (1), loosen (B) it with levers as far as they will go as shown in the figure. 2 : ECM A : Fasten • Pulse signal is measur ...