Nissan Juke Service and Repair Manual : Precautions for Drive Shaft

• Observe the following precautions when disassembling and assembling drive shaft.

- Never disassemble joint sub-assembly because it is non-overhaul parts.

- Perform work in a location which is as dust-free as possible.

- Clean the parts, before disassembling and assembling.

- Prevent the entry of foreign objects during disassembly of the service location.

- Reassemble disassembled parts carefully in the correct order. If work is interrupted, a clean cover must be placed over parts.

- Use paper waste. Fabric shop cloths must not be used because of the danger of lint adhering to parts.

- Clean disassembled parts (except for rubber parts) with kerosene which shall be removed by blowing with air or wiping with paper waste

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all co ...

    Other materials:

    Timer Display
    To provide you with immediate visibility into your vehicle's energy status, the timer display automatically activates for approximately 30 seconds as soon as you place the power switch of your Nissan Leaf in the OFF position. Charging time This section ...

    Glow plug
    Exploded View 1. Glow plug Engine front : N·m (kg-m, ft-lb) Removal and Installation REMOVAL CAUTION: Remove glow plug only if necessary. If carbon adheres, it may be stuck and broken. 1. Disconnect the battery cable from the negative terminal. 2. Remove cowl top extension. Refer to E ...

    Sample/Wiring Diagram -Example-
    Each section includes wiring diagrams. Description SWITCH POSITIONS Switches are shown in wiring diagrams as if the vehicle is in the “normal” condition. A vehicle is in the “normal” condition when: • ignition switch is “OFF”, • doors, hood and trunk lid/back door are ...