Nissan Leaf 2018-2025 (ZE1) Owner's Manual : Power outlet

12V DC power outlet located on the center console of the Nissan Leaf

CAUTION

  • The 12-volt power outlet and the plug of the connected accessory may become hot during or immediately after use. Always handle them with care to avoid minor burns.
  • Do not use this outlet with electrical accessories that exceed a 12-volt, 120W (10A) power draw, as this can overload the electrical circuit.
  • Do not use double adapters or connect more than one electrical accessory to this single power socket simultaneously.
  • Always operate your electronic devices with the Nissan Leaf power switch placed in the ON or READY to Drive position to avoid draining the auxiliary 12-volt battery.
  • Avoid using the power outlet when heavy electrical loads like the air conditioner, high-beam headlights, or rear window defroster are turned on.
  • Push the accessory plug in as far as it will go to ensure a secure connection. If good electrical contact is not made, the plug may overheat or the internal temperature fuse may open, disabling the outlet.
  • Before inserting or disconnecting any plug, make sure that the specific electrical accessory being used is turned completely OFF.
  • When the outlet is not in active use, be sure to close the protective cap securely. Do not allow water, spilled beverages, or any moisture to come into contact with the inner outlet contacts.
    Rear Door Alert
    The integrated Rear Door Alert system acts as a helpful reminder under specific operating conditions, indicating that a child, pet, or valuable object may have been left in the rear seats. Always phys ...

    USB/iPod charging ports
    Type-A USB connection and charging port There are dedicated USB/iPod charging ports conveniently located behind the center console for rear passengers. These ...

    Other materials:

    Shift P warning lamp
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “LCD” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Shift P ...

    Side curtain air bag module
    Exploded View 1. Side curtain air bag module : Metal clip : N·m (kg-m, ft-lb) Removal and Installation WARNING: • Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more. • Always work from the side of curtain air bag module. Never ...

    P0725 engine speed
    Description The engine speed signal is transmitted from ECM to TCM by CAN communication line. DTC Logic DTC DETECTION LOGI DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn igni ...