Nissan Juke Service and Repair Manual : Periodic maintenance

Symptom diagnosis
Noise, vibration and harshnesS (NVH) Troubleshooting NVH Troubleshooting - Engine Noise Use the Chart Below to Help You Find the Cause of the Symptom 1. Locate the area where noise occurs. 2. C ...

Drive belt
Checking Drive Belts WARNING: Be sure to perform when the engine is stopped. 1. Inspect belts for cracks, fraying, wear and oil. If necessary, replace. 2. Evaluate manually if the belt is enough ...

Other materials:

P0868 transmission fluid pressure
Description The secondary pressure solenoid valve regulates the secondary pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATIO ...

A/C indicator
Diagnosis Procedure 1.CHECK SYMPTOM Check symptom. A/C indicator dose not turn ON>>GO TO 2. A/C indicator dose not turn OFF>>GO TO 6. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 10A fuse (No. 15, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Conn ...

Power supply and ground circuit
Diagnosis Procedure 1.CHECK 4WD CONTROL MODULE POWER SUPPLY (1) 1. Turn the ignition switch OFF. 2. Disconnect 4WD control module harness connector. 3. Check the voltage between 4WD control module harness connector and ground. 4. Turn the ignition switch ON. CAUTION: Never start the engin ...