Nissan Juke Service and Repair Manual : P0564 ASCD steering switch

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.CHECK ASCD STEERING SWITCH CIRCUIT

1. Check ASCD steering switch circuit.

ASCD steering switch>>Refer to EC-1011, "Component Function Check" and EC-1011, "Diagnosis Procedure".

ASCD main switch>>Refer to EC-1009, "Component Function Check" and EC-1009, "Diagnosis Procedure".

    P0560 battery voltage
    DTC Logic DTC DETECTION LOGIC NOTE: When IPDM E/R DTC is indicated with DTC P0560, IPDM E/R DTC must be checked first. Diagnosis Procedure 1.CHECK BATTERY VOLTAGE 1. Turn ignition switch ON. ...

    P0574 VSS
    DTC Logic DTC DETECTION LOGIC ...

    Other materials:

    Control buttons
    The control buttons for the Bluetooth® Hands- Free Phone System are located on the steering wheel. PHONE SEND Push the button to initiate a VR session or answer an incoming call. You can also use the button to interrupt system feedback and give a command at once. PHONE END While th ...

    P0706 transmission range sensor A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION ...

    Fuel pressure check
    Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT-III 1. Turn ignition switch ON. 2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode with CONSULT-III. 3. Start engine. 4. After engine stalls, crank it two or three times to release all fuel pressure. 5 ...