Nissan Juke Service and Repair Manual : Information display (ASCD)

Component Function Check

1.CHECK INFORMATION DISPLAY

1. Start engine.

2. Press ASCD MAIN switch.

3. Drive the vehicle at more than 30 km/h (20 MPH) CAUTION:
Always drive vehicle at a safe speed.

4. Press SET/ACCELERATE or SET/COAST switch.

5. Check that the readings of the speedometer show the same values as the set speed indicated in the information display while driving the vehicle on a flat road.

Is the inspection result normal? YES >> INSPECTION END

NO >> Go to EC-1017, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK CAN COMMUNICATION LINE

Refer to LAN-31, "CAN COMMUNICATION SYSTEM : CAN Communication Signal Chart".

OK or NG OK >> GO TO 2.

NG >> Repair or replace.

2.CHECK DTC WITH ???UNIFIED METER AND A/C AMP.???

Refer to MWI-23, "CONSULT-III Function".

Is the inspection result normal? YES >> GO TO 3.

NO >> Perform trouble diagnosis relevant to DTC indicated.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident", ???INCIDENT SIMULATION TESTS??? and ???GROUND INSPECTION???.

Is the inspection result normal? YES >> Replace combination meter.

NO >> Repair or replace.

    Cooling fan
    Diagnosis Procedure 1.CHECK GROUND CONNECTION 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground Inspection in GI-44, "Circuit Inspection". Is the inspectio ...

    Information display (speed limiter))
    Component Function Check 1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION 1. Start engine. 2. Press speed limiter MAIN switch. 3. Drive the vehicle at more than 30 km/h (20 MPH). CAUTION: ...

    Other materials:

    Changing engine oil and filter
    Change the engine oil and filter according to the maintenance log shown in the NISSAN Service and Maintenance Guide. Vehicle set-up 1. Park the vehicle on a level surface and apply the parking brake. 2. Run the engine until it reaches the operating temperature. 3. Turn the engine off and wait ...

    P181E steering angle sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE� has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...

    Keyfob battery
    Component Function Check 1.CHECK FUNCTION Check door lock and unlock operation with keyfob button. Is the inspection result normal? YES >> Keyfob is OK. NO >> Refer to DLK-528, "Diagnosis Procedure". Diagnosis Procedure 1.CHECK KEYFOB BATTERY Check by connecting a r ...