Nissan Juke Service and Repair Manual : Information display (speed limiter))

Component Function Check

1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION

1. Start engine.

2. Press speed limiter MAIN switch.

3. Drive the vehicle at more than 30 km/h (20 MPH).

CAUTION:
Always drive vehicle at a safe speed.

4. Press SET/ACCELERATE or SET/COAST switch.

5. Perform a test drive on a flat road conditions. Check that the speedometer indicated the same value as the set speed indicator on the information display while depressing the accelerator pedal until just before a kickdown occurs.

Is the inspection result normal? YES >> INSPECTION END

NO >> Go to EC-1018, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK CAN COMMUNICATION LINE

Refer to LAN-31, "CAN COMMUNICATION SYSTEM : CAN Communication Signal Chart".

OK or NG OK >> GO TO 2.

NG >> Repair or replace.

2.CHECK DTC WITH ???UNIFIED METER AND A/C AMP.

???

Refer to MWI-23, "CONSULT-III Function".

Is the inspection result normal? YES >> GO TO 3.

NO >> Perform trouble diagnosis relevant to DTC indicated.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident", ???INCIDENT SIMULATION TESTS??? and ???GROUND INSPECTION???.

Is the inspection result normal? YES >> Replace combination meter.

NO >> Repair or replace.

    Information display (ASCD)
    Component Function Check 1.CHECK INFORMATION DISPLAY 1. Start engine. 2. Press ASCD MAIN switch. 3. Drive the vehicle at more than 30 km/h (20 MPH) CAUTION: Always drive vehicle at a safe speed. ...

    Malfunction indicator
    Component Function Check 1.CHECK MI FUNCTION 1. Turn ignition switch ON. 2. Make sure that MI lights up. Is the inspection result normal? YES >> INSPECTION END NO >> Go to EC-1019, ...

    Other materials:

    Wheel sensor
    Front wheel sensor : Exploded View 1. Front LH wheel sensor 2. Front LH wheel sensor harness connector : Vehicle front : N·m (kg-m, in-lb) NOTE: Front RH wheel sensor is symmetrically opposite of LH. Front wheel sensor : Removal and Installat REMOVAL 1. Remove tires. 2. Remove the fend ...

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern vehicle is equipped with many electronic control unit, and eac ...

    B2205 vehicle speed
    Description Vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) via CAN communication to combination meter. DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) Perform “Self Diagno ...