Nissan Juke Owners Manual : Heater and air conditioner
WARNING
• The air conditioner cooling function operates only when the engine is running.
• Do not leave children or adults who would normally require the support of others alone in your vehicle. Pets should not be left alone either. On hot, sunny days, temperatures in a closed vehicle could quickly become high enough to cause severe or possibly fatal injuries to people or animals.
• Do not use the recirculation mode for long periods as it may cause the interior air to become stale and the windows to fog up.
Start the engine and operate the heater and the air conditioner system.
NOTE:
• Odors from inside and outside the vehicle can build up in the air conditioner unit. Odor can enter the passenger compartment through the vents.
• When parking, set the heater and air conditioner controls to turn off air recirculation to allow fresh air into the passenger compartment. This should help reduce odors inside the vehicle.
- Manual air conditioner (if so equipped)
- Automatic air conditioner (with Integrated Control System)
- Operating tips (for automatic air conditioner)
- In-cabin microfilter
- Servicing air conditioner
Side ventilators
Open or close the vents, and adjust the air flow direction of ventilators as
illustrated. ...
Manual air conditioner (if so equipped)
1. Air intake lever (Outside air circulation
/Air recirculation
)
2. Air flow control dial
3. Fan speed control dial
4. A/C (Air Conditioner) button
5. Temperature control dial
6. Rear wind ...
Other materials:
Component parts
Component Parts Location
1. A/C auto amp.
Refer to HAC-12, "Component Parts
Location".
2. ABS actuator and electric unit (control
unit)
Refer to BRC-9, "Component Parts
Location" (without ESP) or BRC-97,
"Component Parts Location" (with
ESP).
3. ECM
Refer t ...
Overspeed at idle speed or on releasing brake
Description
CHART 14: OVERSPEED AT IDLE SPEED OR ON RELEASING BRAKE
Diagnosis Procedure
1.CHECK ENGINE OIL
Check the grade of engine oil. Refer to LU-33, "Inspection".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Replace engine oil. Refer to LU-34, "Re ...
Push-button ignition switch
Component Function Check
1.CHECK FUNCTION
1. Select “PUSH SW� in “Data Monitor� mode with CONSULT-III.
2. Check the push-button ignition switch signal under the following conditions.
Is the indication normal?
YES >> INSPECTION END.
NO >> Go to PCS-108, "Diagnosis Pro ...
