ECM

Removal and Installation REMOVAL 1. Remove fusible link bracket. Keep a service area. 2. Disconnect ECM harness connectors. Refer to PG-4, "Harness Connector". 3. Remove ECM mounting nut ...

Service data and specifications (SDS)

SERVICE DATA AND SPECIFICATIONS (SDS) Idle Speed *: Under the following conditions • A/C switch: OFF • Electric load: OFF (Lights, heater fan & rear window defogger) • Steering wheel: ...

Other materials:

Super lock actuator
Driver side : Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “SUPER LOCK” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES & ...

P1212 TCS communication line
Description This CAN communication line is used to control the smooth engine operation during the TCS operation. Pulse signals are exchanged between ECM and “ABS actuator and electric unit (control unit)”. Be sure to erase the malfunction information such as DTC not only for “ABS ac ...

System
System Description SYSTEM DIAGRAM • The multi display unit transmits the operation status of the drive mode switch to other units via CAN communication as the mode signal (refer below). - NORMAL: ON/OFF - SPORT: ON/OFF - ECO: ON/OFF • Based on the mode signals received from TCM (CVT ...