Nissan Juke Service and Repair Manual : ECM

Removal and Installation

REMOVAL

1. Remove fusible link bracket. Keep a service area.

2. Disconnect ECM harness connectors. Refer to PG-4, "Harness Connector".

3. Remove ECM mounting nuts,and then remove ECM.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
Must be perform additional service when replacing ECM. Refer to EC-541, "Work Procedure".

    Fuel pump control module (FPCM)
    Removal and Installation REMOVAL 1. Remove Luggage side lower finisher LH. Refer to INT-31, "LUGGAGE SIDE LOWER FINISHER : Removal and Installation". 2. Disconnect fuel pump control mo ...

    Other materials:

    P0607 ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC. Is DTC detected? YES >> Proceed to EC-304, "Diagnosis Procedure". NO >> INSPECTION END Diagnosis Procedur 1.INSPECTION START ...

    ABS actuator and electric unit (control unit)
    Exploded View LHD MR16DDT (2WD), HR16DE 1. ABS actuator and electric unit (control unit) 2. ABS actuator and electric unit (control unit) harness connector 3. Bracket A. To front LH caliper B. To rear RH caliper C. To rear LH caliper D. To front RH caliper E. To master cylinder seco ...

    Unlock sensor
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “LOCK STATUS” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Unlo ...