Nissan Juke Service and Repair Manual : Engine does not start when intelligent key is inside of vehicle

Nissan Juke Service and Repair Manual / Security Control System with intelligent key system / Symptom diagnosis / Engine does not start when intelligent key is inside of vehicle

Description

Engine does not start when push-button ignition switch is pressed while carrying Intelligent Key.

NOTE

:
• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom.

• The engine start function, door lock function, power distribution system, and NATS-IVIS/NVIS in the Intelligent Key system are closely related to each other regarding control. The vehicle security function can operate only when the door lock and power distribution system are operating normally.

Conditions of Vehicle (Operating Conditions) • “ENGINE START BY I-KEY”: ON Check the setting of “ENGINE START BY I-KEY” in “Work Support” mode of “INTELLIGENT KEY” of “BCM” using CONSULT-III.

• One or more of Intelligent Keys with registered Intelligent Key ID are in the vehicle.

Diagnosis Procedure

1.PERFORM WORK SUPPORT

Perform “INSIDE ANT DIAGNOSIS” in “Work Support” mode of “INTELLIGENT KEY” of BCM using CONSULT- III.

Refer to SEC-26, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) (With Super Lock)" or SEC-29, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) (Without Super Lock)".

>> GO TO 2.

2.PERFORM SELF-DIAGNOSIS RESULT

Perform Self-Diagnosis Result in “BCM”, and check whether or not DTC of inside key antenna is detected.

Is DTC detected? YES >> Refer to BCS-67, "DTC Index".

NO >> GO TO 3.

3.CHECK PUSH-BUTTON IGNITION SWITCH

Check push-button ignition switch.

Refer to PCS-108, "Component Function Check".

Is the operation normal? YES >> GO TO 4.

NO >> Repair or replace malfunctioning parts.

4.CONFIRM THE OPERATION

Confirm the operation again.

Is the inspection normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 1.

    Steering does not lock
    Description Steering does not lock when door is open while ignition switch is OFF. NOTE: Before performing the diagnosis, check “Work Flow”. Refer to SEC-47, "Work Flow". Diagnos ...

    Other materials:

    Power supply and ground circuit
    Navi control unit NAVI CONTROL UNIT : Diagnosis Procedure 1.CHECK FUSE Check for blown fuses. Is inspection result OK? YES >> GO TO 2. NO >> Be sure to eliminate cause of malfunction before installing new fuse. 2.CHECK POWER SUPPLY CIRCUIT Check voltage between NAVI control ...

    Remote keyless entry receiver
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “RKE OPE COUN1” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >& ...

    Diagnosis and repair workflow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Interview the symptom to the customer. >> GO TO 2. 2.SYMPTOM CHECK Check the symptom from the customer's information. >> GO TO 3. 3.BASIC INSPECTION Check the operation of each part. Check that any s ...