Nissan Juke Service and Repair Manual : Steering does not lock

Description

Steering does not lock when door is open while ignition switch is OFF.

NOTE

:
Before performing the diagnosis, check “Work Flow”. Refer to SEC-47, "Work Flow".

Diagnosis Procedure

1.CHECK DOOR SWITCH

Check door switch.

Refer to DLK-87, "Component Function Check" (With super lock) or DLK-258, "Component Function Check" (Without super lock).

Is the inspection normal? YES >> GO TO 2.

NO >> Repair or replace malfunctioning parts.

2.CHECK DETENTION SWITCH

Check CVT shift selector (detention switch). Refer to SEC-83, "Component Inspection".

Is the inspection normal? YES >> GO TO 3.

NO >> Repair or replace malfunctioning parts.

3.CONFIRM THE OPERATION

Confirm the operation again.

Is the inspection normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 1.

    Engine does not start when intelligent key is inside of vehicle
    Description Engine does not start when push-button ignition switch is pressed while carrying Intelligent Key. NOTE: • Check that vehicle is under the condition shown in “Conditions of vehic ...

    Security indicator lamp does not turn on or blink
    Description Security indicator lamp does not blink when ignition switch is in a position other than ON. NOTE: • Before performing the diagnosis, check “Work Flow”. Refer to SEC-47, " ...

    Other materials:

    P17BB primary pressure solenoid
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...

    B26FC key registration
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Perform initialization of BCM and reregistration of all Intelligent Keys using CONSULT-III. For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NV ...

    Key reminder function does not operate
    Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switch. Refer to DLK-520, "Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. 2.CHECK KEY SWITCH Check k ...