Nissan Juke Service and Repair Manual : Security indicator lamp does not turn on or blink

Description

Security indicator lamp does not blink when ignition switch is in a position other than ON.

NOTE

:
• Before performing the diagnosis, check “Work Flow”. Refer to SEC-47, "Work Flow".

• Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE (OPERATING CONDITIONS)” before starting diagnosis, and check each symptom.

CONDITIONS OF VEHICLE (OPERATING CONDITIONS)

Power supply position is not the ON position.

Diagnosis Procedure

1.CHECK SECURITY INDICATOR LAMP

Check security indicator lamp.

Refer to SEC-159, "Component Function Check".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CONFIRM THE OPERATION

Confirm the operation again.

Is the result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 1.

    Steering does not lock
    Description Steering does not lock when door is open while ignition switch is OFF. NOTE: Before performing the diagnosis, check “Work Flow”. Refer to SEC-47, "Work Flow". Diagnos ...

    Vehicle security system cannot BE set
    INTELLIGENT KEY INTELLIGENT KEY : Description Armed phase is not activated when door is locked using Intelligent Key. NOTE: Check that vehicle is under the condition shown in “CONDITIONS OF VE ...

    Other materials:

    Diagnosis and repair workflow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Interview the symptom to the customer. >> GO TO 2. 2.SYMPTOM CHECK Check the symptom from the customer's information. >> GO TO 3. 3.BASIC INSPECTION Check the operation of each part. Check that any s ...

    None of the power windows can be operated using any switch
    Diagnosis Procedure 1.CHECK BCM POWER SUPPLY AND GROUND CIRCUIT Check BCM power supply and ground circuit. Refer to the following. • With Intelligent Key: Refer to BCS-87, "Diagnosis Procedure". • Without Intelligent Key: Refer to BCS-155, "Diagnosis Procedure". Is t ...

    Back door opener switch
    Component Function Check 1.CHECK FUNCTION 1. Select “TRUNK” of “BCM” using CONSULT-III. 2. Select “TR/BD OPEN SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Back d ...