Handling precaution

NISSAN Dynamic Control System • The engine torque, engine power, boost pressure, and instantaneous fuel consumption are provided for information purposes only. They are not intended to prompt the ...

Wiring diagram

NISSAN DYNAMIC CONTROL SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, &qu ...

Other materials:

Normal operating condition
Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 1,800 rpm under no load (for example, the selector lever position is neutral and engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies b ...

P1616 ECM
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION 1. Turn ignition switch ON amd wait 2 seconds or more. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III. Is DTC detected? YES >> Go to SEC-199, &q ...

Precaution for Liquid Gasket
REMOVAL OF LIQUID GASKET • After removing the mounting bolts and nuts, separate the mating surface using a seal cutter and remove the liquid gasket. CAUTION: Be careful not to damage the mating surfaces. • In areas where the cutter is difficult to use, use a plastic hammer to lightly tap the ...