System

System Diagram System Description REFRIGERANT CYCLE Refrigerant Flow The refrigerant from the compressor, flows the condenser with liquid tank, the evaporator, and returns to the compressor. ...

Diagnosis and repair workflow

Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Interview the symptom to the customer >> GO TO 2. 2.SYMPTOM CHECK Check the symptom from the customer's informatio ...

Other materials:

Service
• Never use electrical test equipment to check SRS circuits unless instructed to in this Service Manual. • Before servicing the SRS, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more. For approximately 3 minutes after the cables are removed, it is still ...

Hazard function
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “FLASHER” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Hazard warning lamp ...

B2562 low voltage
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DTC CONFIRMATION 1. Erase DTC. 2. Turn ignition switch OFF. 3. Perform the “Self Diagnostic Result” of BCM with CONSULT-III, when passed 120 seconds or more after the ignition switch is turned ON. Is any DTC detected? YES > ...