Nissan Juke Service and Repair Manual : U1000 can comm circuit

Description

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-board multiplex communication line with high data communication speed and excellent error detection ability. A modern vehicle is equipped with many ECUs, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, 2 control units are connected with 2 communication lines (CAN-L-line and CAN-H-line) allowing a high rate of information transmission with less wiring.

Each control unit transmits/receives data but selectively reads required data only.

Refer to LAN-31, "CAN COMMUNICATION SYSTEM : CAN Communication Signal Chart" for details of the communication signal.

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.PERFORM SELF-DIAGNOSIS

1. Turn the ignition switch ON and hold it for 2 seconds or more.

2. Using CONSULT-III, check the ”self diagnosis result“ of ”MULTI DISPLAY“.

Is CAN communication system displayed? YES >> Refer to LAN-17, "Trouble Diagnosis Flow Chart".

NO >> Refer to GI-42, "Intermittent Incident".

    U1010 control unit (can)
    Description Initial diagnosis of multi display unit DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.REPLACE THE MULTI DISPLAY UNIT If DTC U1010 is detected, replace the multi display unit. ...

    Other materials:

    Timing chain
    Exploded View 1. Timing chain slack guide 2. Timing chain tensioner 3. Timing chain 4. Oil pump drive chain 5. Crankshaft sprocket 6. Crankshaft key 7. Oil pump sprocket 8. Front cover 9. O-ring 10. O-ring 11. Oil control valve cover 12. O-ring 13. Oil control valve (EXH) 14 ...

    Door sash tape
    Exploded View 1. Front door panel 2. Front door sash tape 3. Rear door sash tape 4. Rear door panel : Do not reuse Front door sash tape FRONT DOOR SASH TAPE : Removal and Installation REMOVAL Heat door sash tape surface using a dryer, and then peel door sash tape. CAUTION: Never dam ...

    P181F incomplete calibration
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...