Nissan Juke Service and Repair Manual : Wiring diagram

Ecu diagnosis information
BCM (body control module) Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES NOTE: • *1: Without automatic A/C • *2: RHD models • *3: ...

BCM
LHD LHD : Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Inform ...

Other materials:

P1553 battery current sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

Compression pressure
Inspection 1. Warm up engine thoroughly. Then, stop it. 2. Release fuel pressure. Refer to EC-551, "Work Procedure". 3. Remove ignition coil and spark plug from each cylinder. Refer to EM-53, "Exploded View". 4. Connect engine tachometer (not required in use of CONSULT-II ...