Nissan Juke Service and Repair Manual : Wiring diagram

Ecu diagnosis information
TCM Reference Value CONSULT-III DATA MONITOR STANDARD VALUE • In CONSULT-III, electric shift timing or lock-up timing, i.e. operation timing of each solenoid valve, is displayed. Therefore, if ...

CVT control system
Wiring diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Expla ...

Other materials:

Water outlet
Exploded View 1. Engine coolant temperature sensor 2. O-ring 3. Lock plate 4. Gasket 5. Water outlet and thermostat assembly 6. Air relief plug 7. Clamp 8. Water hose 9. Water pipe A. To radiator hose upper B. To EGR cooler hose C. To heater hose : N·m (kg-m, ft-lb) : Always ...

P0078 EVT control solenoid valve
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Hazard switch
Component Function Check 1.CHECK HAZARD SWITCH SIGNAL BY CONSULT-III CONSULT-III DATA MONITOR 1. Turn the ignition switch ON. 2. Select “HAZARD SW” of BCM (FLASHER) data monitor item. 3. With operating the hazard switch, check the monitor status. Is the inspection result normal? YES >> ...