Nissan Juke Service and Repair Manual : CVT shift lock system

Wiring diagram

connector terminal arrangements, harness layouts, and alphabets in a described in wiring diagram), refer to GI-12, "Connector Information/Explanation(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation".

Basic inspection


    CVT control system
    Wiring diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Expla ...

    Other materials:

    Unit disassembly and assembly
    Torque converter and converter housing oil seal Exploded View 1. Transaxle assembly 2. Converter housing oil seal 3. Torque converter : Always replace after every disassembly. : Apply CVT Fluid NS-2. Disassembly 1. Remove transaxle assembly. Refer to TM-301, "Removal and Installat ...

    Draining
    1. Start engine and let it run to warm up transaxle. 2. Stop engine. Remove drain plug (1) and gasket, using a socket [Commercial service tool] and then drain gear oil. 3. Set a gasket on drain plug and install it to clutch housing, using a socket [Commercial service tool]. CAUTION: Never re ...

    B2562 low voltage
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DTC CONFIRMATION 1. Erase DTC. 2. Turn ignition switch OFF. 3. Perform the “Self Diagnostic Result” of BCM with CONSULT-III, when passed 120 seconds or more after the ignition switch is turned ON. Is any DTC detected? YES ...