Nissan Juke Owners Manual : Vehicle identification
- Vehicle Identification Number (VIN) plate
- Vehicle identification number (chassis number)
- Engine serial number
- F.M.V.S.S./C.M.V.S.S. certification label
- Emission control information label
- Tire and Loading Information label
- Air conditioner specification label
When traveling or registering your vehicle in another country
When planning to travel in another country, you should first find out if the
fuel available is suitable for your vehicle’s engine.
Using fuel with an octane rating that is too low may cause engine ...
Vehicle Identification Number (VIN) plate
The vehicle identification number plate is attached as shown. This number is
the identification for your vehicle and is used in the vehicle registration. ...
Other materials:
Nats antenna AMP
Removal and Installation
REMOVAL
1. Remove the cluster lid A. Refer to IP-13, "Removal and Installation".
2. Remove the NATS antenna amp.
1. Disengage the NATS antenna amp. (1) fixing pawls using
minus driver etc.
2. Pull NATS antenna amp. to remove it from push-button ignition
sw ...
Removal and Installation
REMOVAL
1. Disconnect accelerator pedal position sensor harness connector.
2. Loosen mounting bolts, and remove accelerator pedal assembly.
CAUTION:
• Never disassemble accelerator pedal assembly. Never remove accelerator pedal
position sensor
from accelerator pedal assembly.
• Avoid impac ...
P1745 line pressure control
Description
The line pressure solenoid valve regulates the oil pump discharge pressure to
suit the driving condition in
response to a signal sent from the TCM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, alw ...