Vehicle identification number (chassis number)

The vehicle identification number is located as shown. Remove the cover to access the number. ...

F.M.V.S.S./C.M.V.S.S. certification label

The Federal/Canadian Motor Vehicle Safety Standards (F.M.V.S.S./C.M.V.S.S.) certification label is affixed as shown. This label contains valuable vehicle information, such as: Gross Vehicle Weig ...

Other materials:

P0130 A/F sensor 1
DTC Logic DTC DETECTION LOGIC To judge the malfunction, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal fluctuates according to fuel feedback control. DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conduc ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

Ignition signal
Component Function Check 1.INSPECTION START Turn ignition switch OFF, and restart engine. Does the engine start? YES >> GO TO 2. NO >> Proceed to EC-414, "Diagnosis Procedure". 2.IGNITION SIGNAL FUNCTION With CONSULT-III 1. Perform “POWER BALANCE” in “ACTIVE ...