Nissan Juke Owners Manual : Variable voltage control system
CAUTION
• Do not ground accessories directly to the battery terminal. Doing so will bypass the variable voltage control system and the vehicle battery may not charge completely.
• Use electrical accessories with the engine running to avoid discharging the vehicle battery.
The variable voltage control system measures the amount of electrical discharge from the battery and controls voltage generated by the generator.
Battery
• Keep the battery surface clean and dry.
Clean the battery with a solution of baking soda and water.
• Make certain the terminal connections are clean and securely tightened.
• If the ...
Drive belt
1. Alternator
2. Drive belt auto-tensioner
3. Crankshaft pulley
4. Air conditioner compressor
5. Water pump
WARNING
Be sure the ignition switch is in the OFF or LOCK position before servicing ...
Other materials:
4WD warning lamp blinks slowly
Description
4WD warning lamp blinks at approximately 2 seconds intervals while driving.
Diagnosis Procedure
1.CHECK TIRE
Check the following.
• Tire pressure
• Wear condition
• Front and rear tire size (There is no difference between front and rear
tires.)
Is the inspection result ...
Steering Assist temporary standby
Automatic standby due to driving operation:
When you engage the turn signal to initiate a lane change or turn, the Steering Assist system in your Nissan Leaf is temporarily placed into a standby mode to allow for your manual input. The system will seamlessly restart and resume active lane cente ...
None of the power windows can be operated using any
switch
Diagnosis Procedure
1.CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Check BCM power supply and ground circuit. Refer to the following.
• With Intelligent Key: Refer to BCS-87, "Diagnosis Procedure".
• Without Intelligent Key: Refer to BCS-155, "Diagnosis Procedure".
Is t ...
