Nissan Juke Owners Manual : Drive belt

1. Alternator


1. Alternator
2. Drive belt auto-tensioner 3. Crankshaft pulley
4. Air conditioner compressor 5. Water pump

WARNING

Be sure the ignition switch is in the OFF or LOCK position before servicing drive belts. The engine could rotate unexpectedly.

1. Visually inspect the belt for signs of unusual wear, cuts, fraying or looseness. If the belt is in poor condition or loose, have it replaced or adjusted by a NISSAN dealer.

2. Have the belt condition checked regularly.

    Variable voltage control system
    CAUTION • Do not ground accessories directly to the battery terminal. Doing so will bypass the variable voltage control system and the vehicle battery may not charge completely. • Use electr ...

    Spark plugs
    WARNING Be sure the engine and ignition switch are off and that the parking brake is engaged securely. CAUTION Be sure to use the correct socket to remove the spark plugs. An incorrect socket c ...

    Other materials:

    Unbalance steering wheel turning force (torque variation)
    Description Unbalance steering wheel turning force (torque variation). Diagnosis Procedure 1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP Check the EPS warning lamp while engine is running. Does the EPS warning lamp turn OFF? YES >> GO TO 2. NO >> Refer to STC-28, "Diag ...

    Models without Intelligent Key system
    1. Apply the parking brake. 2. Continuously Variable Transmission (CVT) models: Move the shift lever to the P (Park) or N (Neutral) position. (P is recommended.) The starter is designed so that it does not operate unless the shift lever is in either of the above positions. Manual Transmission ...

    B26F2 ignition relay
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON under the following conditions, and wait for 2 seconds or more. CVT models - Selector lever is in the P or N position - Do not depress brake pedal M/T models - Do n ...