Nissan Juke Owners Manual : Spark plugs

WARNING

Be sure the engine and ignition switch are off and that the parking brake is engaged securely.

CAUTION

Be sure to use the correct socket to remove the spark plugs. An incorrect socket can damage the spark plugs.

REPLACING SPARK PLUGS


REPLACING SPARK PLUGS

If replacement is required, see a NISSAN dealer for servicing.

Iridium platinum-tipped spark plugs It is not necessary to replace the iridium platinum-tipped spark plugs as frequently as the conventional type spark plugs since they will last much longer. Follow the maintenance log shown in the “NISSAN Service and Maintenance Guide”. Do not reuse the iridium platinum- tipped spark plugs by cleaning or regapping.

Always replace spark plugs with recommended or equivalent ones.

    Drive belt
    1. Alternator 2. Drive belt auto-tensioner 3. Crankshaft pulley 4. Air conditioner compressor 5. Water pump WARNING Be sure the ignition switch is in the OFF or LOCK position before servicing ...

    Air cleaner
    To remove the filter, pull the air duct1 upward to remove it. Pull the tabs 2 , then pull the cover3 upward. The air cleaner filter should not be cleaned and reused. Replace it according to the ...

    Other materials:

    The fuel gauge indicator does not operate
    Description Fuel gauge will not indicate from a certain position. Diagnosis Procedure 1.CHECK COMBINATION METER OUTPUT SIGNAL 1. Connect CONSULT-III. 2. Select the “Data Monitor” for the “METER/M&A” and compare the “FUEL METER” monitor value with the fuel gauge reading on the ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

    B26F5 steering lock status switch
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26F5 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26F5 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, &qu ...