Unit removal and installation

Transaxle assembly Exploded View 1. Transaxle assembly : Refer to "INSTALLATION" in TM-30, "Removal and Installation" for the locations and tightening torque. Removal and I ...

Transaxle assembly

Exploded View CASE AND HOUSING 1. Differential side oil seal 2. Clutch housing 3. 2 way connector 4. Oil gutter 5. Air breather inner tube 6. Filler plug 7. Gasket 8. Transaxle case 9 ...

Other materials:

Front disc brake
Brake pad : Inspection and Adjustment INSPECTION Check brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary. Wear thickness : Refer to BR-71, "Front Disc Brake". ADJUSTMENT Burnish contact surfaces between disc rotor and brake pads acc ...

Steering switch signal a circuit
Description Transmits the steering switch signal to audio unit. Diagnosis Procedure 1.CHECK STEERING SWITCH SIGNAL A CIRCUIT 1. Disconnect audio unit connector and spiral cable connector. 2. Check continuity between audio unit harness connector and spiral cable harness connector. 3. Check ...

P0037, P0038 HO2S2 heater
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switc ...