Nissan Juke Service and Repair Manual : U1010 control unit (can)

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.REPLACE BCM

When DTC “U1010” is detected, replace BCM.

>> Replace BCM. Refer to BCS-93, "Removal and Installation".

    U1000 can comm
    Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excelle ...

    U0415 vehicle speed
    Description U0415 is displayed if any unusual condition is present in the reception status of the vehicle speed signal from the ABS actuator and electric unit (control unit). DTC Logic DTC DETEC ...

    Other materials:

    Symptom diagnosis
    NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH troubleshooting Chart 1. Locate the area where noise occurs. 2. Confirm the type of noise. 3. Specify the operating condition of engine 4. Check specified noise source. If necessary, repair or replace these parts. A: Closely rela ...

    Motor compartment check locations
    Fuse/Fusible link holder Brake fluid reservoir 12-volt battery Fuse holder Windshield-washer fluid reservoir Fuse/Fusible link holder Coolant reservoir cap NOTE: Depending on your specific model and ...

    Steering wheel
    Exploded View 1. Steering wheel : Always replace after every disassembly. : N·m (kg-m, ft-lb) Removal and Installation REMOVAL NOTE: When reconnecting spiral cable, fix cable with a tape so that fixing case and rotating part keep aligned. This will omit neutral position alignment proc ...