Nissan Juke Service and Repair Manual : Tweeter
Removal and Installation
REMOVAL
1. Remove front pillar garnish. Refer to INT-18, "Exploded View".
2. Remove tweeter clip, then disconnect tweeter connector and remove tweeter.
INSTALLATION
Install in the reverse order of removal.
Front door speaker
Removal
and Installation
REMOVAL
1. Remove front door finisher. Refer to INT-13, "Exploded View".
2. Remove front door speaker screws, then disconnect front door speaker
connector and ...
Rear door speaker
Removal and Installation
REMOVAL
1. Remove rear door finisher. Refer to INT-16, "Exploded View".
2. Remove rear door speaker screws, then disconnect rear door speaker connector
and remo ...
Other materials:
Blower motor
Diagnosis Procedure
1.CHECK SYMPTOM
Check symptom (A or B).
Which symptom is detected?
A >> GO TO 2.
B >> GO TO 7.
2.CHECK FUSE
1. Turn ignition switch OFF.
2. Check 15A fuses (Nos. 14 and 16, located in fuse block (J/B)].
NOTE:
Refer to PG-22, "Fuse, Connector and ...
Disposal of air bag module
Driver air bag module : Deployment
CHECKING DEPLOYMENT TOOL
Connecting to Battery
CAUTION:
The battery must show voltage of 9.6 V or more.
Remove the battery from the vehicle and place it on dry wood blocks
approximately 5.0 m (16.4 ft) away from the vehicle.
• Wait 3 minutes after the vehi ...
P0524 engine oil pressure
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0524 is displayed with DTC P0520, P0075, or P0081, perform trouble
diagnosis for DTC P0520,
P0075, or P0081 first. Refer to EC-176, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previo ...
