Tweeter

Removal and Installation REMOVAL 1. Remove front pillar garnish. Refer to INT-18, "Exploded View". 2. Remove tweeter clip, then disconnect tweeter connector and remove tweeter. INSTALL ...

Antenna base

Exploded View 1. Antenna rod 2. Antenna base : N·m (kg-m, in-lb) Removal and Installation REMOVAL 1. Remove headlining. Refer to INT-26, "Exploded View". 2. Disconnect antenna fee ...

Other materials:

Adjustment of steering angle sensor neutral position
Description Always adjust the neutral position of steering angle sensor before driving when the following operation is performed. Work Procedure ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SENSOR CAUTION: Always use CONSULT-III when adjusting the neutral position of steering angle senso ...

P1220 fuel pump control module (FPCM)
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. Turn ignition switch OFF and wait at least 10 seconds. TESTING CONDITION: • Before performing the following procedure, con ...

P1813 4WD mode switch
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...