Nissan Juke Service and Repair Manual : Antenna base
Exploded View
1. Antenna rod
2. Antenna base
: N·m (kg-m, in-lb)
Removal and Installation
REMOVAL
1. Remove headlining. Refer to INT-26, "Exploded View".
2. Disconnect antenna feeder connector.
3. Remove nut to remove antenna base.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
If the antenna base mounting nut is tightened looser than the specified torque,
then this will lower the
sensitivity of the antenna. On the other hand, if the nut is tightened tighter
than the specified torque,
then this will deform the roof panel.
Rear door speaker
Removal and Installation
REMOVAL
1. Remove rear door finisher. Refer to INT-16, "Exploded View".
2. Remove rear door speaker screws, then disconnect rear door speaker connector
and remo ...
Microphone
Removal and Installation
REMOVAL
1. Remove headlining. Refer to INT-26, "Exploded View".
2. Remove microphone connector and pawl to remove microphone.
INSTALLATION
Install in the reve ...
Other materials:
Cylinder block
Exploded View
1. Crankshaft position sensor (POS) cover
2. Crankshaft position sensor (POS)
3. O-ring
4. Drain plug
5. Cylinder block
6. Oil level gauge
7. Oil level gauge guide
8. O-ring
9. Knock sensor
10. Oil temperature sensor
11. Oil pressure sensor
12. Oil jet
13. Top rin ...
Rear combination lamp
Exploded View
REMOVAL
1. Grommet
2. Grommet
3. Rear combination lamp
: Clip
: N·m (kg-m, in-lb)
DISASSEMBLY
1. Rear combination lamp housing assembly
2. Back-up lamp bulb
3. Harness connector
4. Rear turn signall lamp bulb
5. Stop/tail lamp bulb
Removal and Installation
CAUTI ...
Wiper and washer system
Wiring Diagram - WIPER AND WASHER SYSTEM -
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
