Audio unit

Removal and Installation REMOVAL 1. Remove cluster lid C. Refer to IP-12, "Exploded View". 2. Remove audio unit screws. 3. Disconnect audio unit connectors to remove audio unit and brack ...

Tweeter

Removal and Installation REMOVAL 1. Remove front pillar garnish. Refer to INT-18, "Exploded View". 2. Remove tweeter clip, then disconnect tweeter connector and remove tweeter. INSTALL ...

Other materials:

G sensor calibration
Description ECM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed. • Removal/installation or replacement of G sensor • Replacement of ECM W ...

Checking engine oil level
1. Park the vehicle on a level surface and apply the parking brake. 2. Run the engine until it reaches operating temperature. 3. Turn off the engine. Wait more than 10 minutes for the oil to drain back into the oil pan. 4. Remove the dipstick and wipe it clean. Reinsert it all the way. 5. R ...

Exploded View
1. Main muffler 2. Mounting rubber 3. Ring gasket 4. Center tube 5. Exhaust gas temperature sensor 2 6. Diesel particulate filter assembly 7. Gasket 8. Stud bolt 9. Diesel particulate filter inlet tube 10. Gasket A. To exhaust manifold B. To pressure hose : N·m (kg-m, ft-lb) : ...