Fuel-filler cap

To remove the fuel-filler cap: 1. Turn the fuel-filler cap counterclockwise 1 to remove. 2. Put the fuel-filler cap on the cap holder A while refueling. To install the fuel-filler cap: 1. Insert ...

Sun visors

TILT OPERATION Push the lock lever down 1 and adjust the steering wheel up or down 2 to the desired position. Pull the lock lever up 3 securely to lock the steering wheel in place. 1. To bloc ...

Other materials:

P0112, P0113 IAT sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

B26E8 clutch interlock switch
DTC Logic NOTE: • If DTC B26E8 is displayed with DTC B210F, first perform the trouble diagnosis for DTC B210F. Refer to BCS-83, "DTC Logic". • If DTC B26E8 is displayed with DTC B2110, first perform the trouble diagnosis for DTC B2110. Refer to BCS-84, "DTC Logic". DT ...

Drive belt
Checking • Inspection should be done only when engine is cold or over 30 minutes after the engine is stopped. 1 : Alternator 2 : Water pump 3 : Crankshaft pulley 4 : A/C compressor 5 : Idler pulley 6 : Drive belt • Visually check belts for wear, damage, and cracks on inside and edges. ...