Nissan Juke Service and Repair Manual : Thermostat

Heater Thermostat (CVT models)


    Radiator
    ...

    Other materials:

    Combination switch output circuit
    Diagnosis Procedure 1.CHECK OUTPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors. 3. Check continuity between BCM harness connector and combination switch harness connector. Does continuity exist? YES >> GO TO 2. NO >> ...

    Brake fluid
    Inspection BRAKE FLUID LEVEL Check that the fluid level in the reservoir tank is within the specified range (MAX MIN lines). Visually check for any brake fluid leakage around the reservoir tank. Check the brake system for any leakage if the fluid level is extremely low (lower than MIN ...

    B2190 nats antenna AMP
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in Self Diagnostic Result mode of BCM using CONSULT-III. Is DTC detected? YES >> Refer to SEC-200, "Diagnosis Procedure". NO >&g ...