Precaution Necessary for Steering Wheel Rotation after Battery Disconnect

NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all co ...

Component parts

Component Parts Location 1. Push-button ignition switch 2. Stop lamp switch Refer to BRC-9, "Component Parts Location" (without EPS), BRC-97, "Component Parts Location" (wi ...

Other materials:

Front drive shaft
Exploded View LEFT SIDE 1. Circular clip 2. Dust shield 3. Housing assembly 4. Boot band 5. Boot 6. Damper band 7. Dynamic damper 8. Circular clip 9. Joint sub-assembly : Wheel side : Fill NISSAN Genuine grease or equivalent. : Always replace after every disassembly. RIGHT ...

System
System Description • The system switches fluid pressure of each brake caliper to increase, to hold or to decrease according to signals from control unit in ABS actuator and electric unit (control unit). This control system is applied to ABS function and EBD function. • Fail-safe function ...

Assembly and Installation
• Use torque wrench to tighten bolts or nuts to specification. • When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, ...