Precaution Necessary for Steering Wheel Rotation after Battery Disconnect

NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all contro ...

Component parts

INTERIOR LIGHTING SYSTEM INTERIOR LIGHTING SYSTEM : Component Parts Location 1. IPDM E/R Refer to PCS-5, "Component Parts Location" 2. BCM Refer to BCS-6, "BODY CONTROL SYSTEM ...

Other materials:

P1777 step motor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, p ...

Front wheel hub and K
Exploded View 1. Steering knuckle 2. Splash guard 3. Hub bolt 4. Wheel hub assembly (Bearing-integrated type) 5. Disc rotor 6. Wheel hub lock nut 7. Adjusting cap 8. Cotter pin A. Tightening must be done following the installation procedure. Refer to FAX-68, "Removal and Insta ...

Combination switch output circuit
Diagnosis Procedure 1.CHECK OUTPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors. 3. Check continuity between BCM harness connector and combination switch harness connector. Does continuity exist? YES >> GO TO 2. NO >> ...