Preparation

Commercial Service Tool Clip List ...

Component parts

Heated seat system : Component Parts Location 1. Seat heater 2. Heated seat switch 3. Heated seat relay A. Front seat B. Front LH of passenger room Heated seat system : Component Descriptio ...

Other materials:

Refilling
1. Remove filler plug (1) and gasket. Then fill oil up to mounting hole for the filler plug. : Vehicle front Oil and viscosity : Refer to MA-13, "Fluids and Lubricants". Oil capacity : Refer to DLN-117, "General Specifications". CAUTION: Carefully fill the oil. (Fill up ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

P0847 transmission fluid pressure SEN/SW B
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION With ...