Precaution for Work

• When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to protect it with a shop cloth. • When removing (dis ...

System description

...

Other materials:

Main line betweeN DLC and MDU circuit
Diagnosis Procedure 1.CHECK HARNESS CONTINUITY (OPEN CIRCUIT) 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect the following harness connectors. - ECM - Multi display unit 4. Check the continuity between the data link connector and the ...

Engine control system
Engine control system : Component Parts Location ENGINE ROOM COMPARTMENT 1. Boost control actuator 2. Turbocharger boost control solenoid valve 3. A/F sensor 1 4. Recirculation valve 5. EVAP canister purge volume control solenoid valve 6. Inter cooler 7. Refrigerant pressure sensor R ...

Performance test
Inspection INSPECTION PROCEDURE 1. Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge. 2. Start the engine, and set to the following condition. Test condition 3. Maintain test condition until A/C system becomes stable. (Approximately 10 minutes) 4. Check t ...