Nissan Juke Service and Repair Manual : System description

Service
• Never use electrical test equipment to check SRS circuits unless instructed to in this Service Manual. • Before servicing the SRS, turn ignition switch OFF, disconnect battery negative term ...

Component parts
Component Parts Location 1. Combination meter Refer to MWI-4, "METER SYSTEM : Component Parts Location". 2. Combination switch (spiral cable) 3. Driver air bag module Crash zone sen ...

Other materials:

P1642 thermoplunger control unit
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect thermoplunger control unit harness connector. 3. Check the voltage between thermoplunger control unit harness connector and ground. Is the ...

B1186, B1187, B1188, B1189, B1190, B1191 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...

Body component parts
Underbody Component Parts (2WD Models) : Both sided anti-corrosive precoated steel sections : High strength steel (HSS) sections : Both sided anti-corrosive steel and HSS sections NOTE: • For the parts without a number described in the figure, it is supplied only with the assembly ...